<?xml version="1.0" encoding="UTF-8"?>
<!DOCTYPE root>
<article xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xmlns:ali="http://www.niso.org/schemas/ali/1.0/" article-type="research-article" dtd-version="1.2" xml:lang="en"><front><journal-meta><journal-id journal-id-type="publisher-id">Russian Journal of Dentistry</journal-id><journal-title-group><journal-title xml:lang="en">Russian Journal of Dentistry</journal-title><trans-title-group xml:lang="ru"><trans-title>Российский стоматологический журнал</trans-title></trans-title-group></journal-title-group><issn publication-format="print">1728-2802</issn><issn publication-format="electronic">2413-2934</issn><publisher><publisher-name xml:lang="en">Eco-Vector</publisher-name></publisher></journal-meta><article-meta><article-id pub-id-type="publisher-id">55273</article-id><article-id pub-id-type="doi">10.17816/1728-2802-2020-24-4-256-261</article-id><article-categories><subj-group subj-group-type="toc-heading" xml:lang="en"><subject>Organization of Healthcare Service</subject></subj-group><subj-group subj-group-type="toc-heading" xml:lang="ru"><subject>Организация здравоохранения</subject></subj-group><subj-group subj-group-type="article-type"><subject>Research Article</subject></subj-group></article-categories><title-group><article-title xml:lang="en">Assessment of the capabilities of orthopedic departments of medical organizations to implement modern technologies</article-title><trans-title-group xml:lang="ru"><trans-title>Оценка возможностей ортопедических отделений медицинских организаций к внедрению современных технологий</trans-title></trans-title-group></title-group><contrib-group><contrib contrib-type="author"><name-alternatives><name xml:lang="en"><surname>Gvetadze</surname><given-names>R. S.</given-names></name><name xml:lang="ru"><surname>Гветадзе</surname><given-names>Р. Ш.</given-names></name></name-alternatives><address><country country="RU">Russian Federation</country></address><email>butova49@rambler.ru</email><xref ref-type="aff" rid="aff1"/></contrib><contrib contrib-type="author"><name-alternatives><name xml:lang="en"><surname>Butova</surname><given-names>Valentina G.</given-names></name><name xml:lang="ru"><surname>Бутова</surname><given-names>Валентина Гавриловна</given-names></name></name-alternatives><address><country country="RU">Russian Federation</country></address><bio xml:lang="en"><p>MD, PhD, Dsc., Prof.</p></bio><bio xml:lang="ru"><p>доктор медицинских наук, профессор</p></bio><email>butova49@rambler.ru</email><xref ref-type="aff" rid="aff1"/></contrib><contrib contrib-type="author"><name-alternatives><name xml:lang="en"><surname>Timofeev</surname><given-names>D. E.</given-names></name><name xml:lang="ru"><surname>Тимофеев</surname><given-names>Д. Е.</given-names></name></name-alternatives><address><country country="RU">Russian Federation</country></address><email>butova49@rambler.ru</email><xref ref-type="aff" rid="aff1"/></contrib><contrib contrib-type="author"><name-alternatives><name xml:lang="en"><surname>Andreeva</surname><given-names>S. N.</given-names></name><name xml:lang="ru"><surname>Андреева</surname><given-names>С. Н.</given-names></name></name-alternatives><address><country country="RU">Russian Federation</country></address><email>butova49@rambler.ru</email><xref ref-type="aff" rid="aff1"/></contrib></contrib-group><aff-alternatives id="aff1"><aff><institution xml:lang="en">Scientific Medical Research Center of Dentistry and Maxillofacial Surgery of the Ministry of Health of Russia</institution></aff><aff><institution xml:lang="ru">ФГБУ «Национальный медицинский исследовательский центр стоматологии и челюстно-лицевой хирургии» Минздрава России</institution></aff></aff-alternatives><pub-date date-type="pub" iso-8601-date="2020-08-15" publication-format="electronic"><day>15</day><month>08</month><year>2020</year></pub-date><volume>24</volume><issue>4</issue><issue-title xml:lang="en"/><issue-title xml:lang="ru"/><fpage>256</fpage><lpage>261</lpage><history><date date-type="received" iso-8601-date="2020-12-16"><day>16</day><month>12</month><year>2020</year></date><date date-type="accepted" iso-8601-date="2020-12-16"><day>16</day><month>12</month><year>2020</year></date></history><permissions><copyright-statement xml:lang="en">Copyright ©; 2020, Eco-Vector</copyright-statement><copyright-statement xml:lang="ru">Copyright ©; 2020, ООО "Эко-Вектор"</copyright-statement><copyright-year>2020</copyright-year><copyright-holder xml:lang="en">Eco-Vector</copyright-holder><copyright-holder xml:lang="ru">ООО "Эко-Вектор"</copyright-holder><ali:free_to_read xmlns:ali="http://www.niso.org/schemas/ali/1.0/" start_date="2023-08-15"/></permissions><self-uri xlink:href="https://rjdentistry.com/1728-2802/article/view/55273">https://rjdentistry.com/1728-2802/article/view/55273</self-uri><abstract xml:lang="en"><p>The study showed the presence of negative dynamics in the provision of the population with orthopedic dentists and dental technicians, as well as a decrease in the staffing of medical organizations with these specialists. The fact of exceeding the basic rate of loss of dental technicians over the same indicator for dentists-orthopedists by 2 times was established. Since the coefficient of concurrency among dentists-orthopedists and dental technicians is less than the average for the specialty, the possibility of increasing the availability of personnel by combining positions is revealed. The trends of decreasing interest of specialists in obtaining qualification categories are noted. According to the survey of 305 specialists, a model of the most probable structural “profile” of a dentist-orthopedist was created and the characteristic features of the learning processes and practical use of knowledge on the main new technologies in orthopedic dentistry were determined. There are limited opportunities to improve the availability and quality of dental orthopedic care and the introduction of new prosthetics technologies as indicated by the data obtained in the course of the study.</p></abstract><trans-abstract xml:lang="ru"><p>Проведенное исследование убедительно показало наличие отрицательной динамики в обеспеченности населения врачами — стоматологами-ортопедами и зубными техниками, а также снижение укомплектованности медицинских организаций этими специалистами. Установлен факт превышения базового темпа убыли зубных техников над этим же показателем у врачей — стоматологов-ортопедов в 2 раза. Выявлена возможность увеличения обеспеченности кадрами за счет совмещения должностей, поскольку коэффициент совместительства у врачей — стоматологов-ортопедов и зубных техников меньше, чем в среднем по специальности. Отмечены тенденции снижения заинтересованности специалистов в получении квалификационных категорий. По данным опроса 305 специалистов создана модель наиболее вероятностного структурного «профиля» врача — стоматолога-ортопеда и определены характерные особенности процессов обучения и практического использования знаний по основным новым технологиям в ортопедической стоматологии. Полученные в ходе исследования данные свидетельствуют об ограничении возможностей повышения доступности и качества стоматологической ортопедической помощи и внедрения новых технологий протезирования.</p></trans-abstract><kwd-group xml:lang="en"><kwd>indicators of work of the dentist-orthopedist</kwd></kwd-group><kwd-group xml:lang="ru"><kwd>показатели деятельности ортопедических отделений</kwd></kwd-group><funding-group/></article-meta></front><body></body><back><ref-list><ref id="B1"><label>1.</label><citation-alternatives><mixed-citation xml:lang="en">Ryakhovsky AN. New concept of 4D virtual planning in dentistry. Tsifrovaya stomatologiya. 2019;10(1):11–21. (in Russian)</mixed-citation><mixed-citation xml:lang="ru">Ряховский А.Н. Новая концепция 4Д виртуального планирования в стоматологии. Цифровая стоматология. 2019;10(1):11–21.</mixed-citation></citation-alternatives></ref><ref id="B2"><label>2.</label><citation-alternatives><mixed-citation xml:lang="en">Astvatsatryan LE, Gazhva SI. Modern aspects of the use of 3D technologies in the manufacture of removable dentures. Sovremennye problemy nauki i obrazovaniya. 2017;(5):194. (in Russian)</mixed-citation><mixed-citation xml:lang="ru">Аствацатрян Л.Э., Гажва С.И. Современные аспекты использования 3D-технологий в изготовлении съёмных зубных протезов. Современные проблемы науки и образования. 2017;(5):194.</mixed-citation></citation-alternatives></ref><ref id="B3"><label>3.</label><citation-alternatives><mixed-citation xml:lang="en">Ryakhovsky AN, Tikhon YuV. Analysis of color characteristics in various combinations of the material of the stump of the tooth and the material of the frame of the fixed prosthesis. Rossiiskii stomatologicheskii zhurnal. 2018;22(1):50–4. (in Russian)</mixed-citation><mixed-citation xml:lang="ru">Ряховский А.Н., Тихон Ю.В. Анализ цветовых характеристик при различных сочетаниях материала культи зуба и материала каркаса несъем-ного протеза. Российский стоматологический журнал. 2018;22(1):50–4.</mixed-citation></citation-alternatives></ref><ref id="B4"><label>4.</label><citation-alternatives><mixed-citation xml:lang="en">Gvetadze RSh, Timofeeva DE, Butova VG, Andreeva SN. Digital technologies in dentistry. Rossiiskii stomatologicheskii zhurnal. 2018;22(5):224–8. (in Russian)</mixed-citation><mixed-citation xml:lang="ru">Гветадзе Р.Ш., Тимофеев Д.Е., Бутова В.Г., Андреева С.Н. Цифровые технологии в стоматологии. Российский стоматологический журнал. 2018;22(5):224–8.</mixed-citation></citation-alternatives></ref></ref-list></back></article>
